FTDI2232d + TM4C1294 configurations

I posted this question before, but I am still struggling with this.
I captured a schematic and others in this time so it should be more clear to see what’s going on.

I was given a custom board including Tiva C TM4C1294 + other components on it. Unlike EK-TM4C, FTDI2232d is applied on the custom board.

I have tried to configure ft2232 using FT Prog and programmed .bin into the custom board, but nothing works so far.

Here is a schematic for FT2232D interfacing TM4C:

Here is My Computer’s hardware Configurations:

Here is how I set up using FT Prog:

I have chose other options but nothing works. According to the schematic Ch A is MPSSE mode

Also I have tried on different options, but…

For the Ch B, 232 UART and Virtual Com Port are selected.

As I program .bin into the custom board. It says “unable to find a target”
I am not sure what is wrong with it.

Thanks,
Jin